Automatic capsule filling machine maintenance

Automatic capsule filling machine maintenance 

1 Automatic capsule filling machine using intermittent movement and multi-position hole plug metering method, is set capsule turn around, the sac, filling, culling waste, the capsule, finished products and other processes in one of the automatic capsule filling equipment. 2 operators and maintenance personnel should be in strict accordance with the operating procedures and maintenance procedures to operate, do not violate the operation, to ensure the normal production. 3 operators should add a food-grade lubricant to each refueling point every week, and the inner cam roller face is coated with a food grade grease once a week. 4 The components on the table do not allow the use of gasoline, kerosene, ether, acetone and other solvents to clean, can be fine cloth or absorbent cotton dipped in alcohol for cleaning and wiping. Maximum of 1200 capsules/min. 5 transmission gearbox Every six months to add new oil, every two years should be replaced by lubricating oil (shell # Gear oil) 6 regulatory bodies and electrical parts must be flexible, reliable, the machine in the process of operation is strictly prohibited by hand or object contact with all parts of the operation, touch screen is strictly prohibited water cleaning. 7 equipment in the operation of the process is strictly prohibited by hand, objects rub its rotating parts to prevent the occurrence of dangerous. 8 each time after the replacement of the mold in the boot must be used to pull the main motor hand wheel, so that the machine running the circle. Require the machine to operate flexible, no abnormal resistance, can boot into production. Note: 1). Automatic operation must be closed glass doors, such as the opening of plexiglass doors, safety lights out, the machine will stop changing careers. 2). Automatic operation of the vacuum pump, the main motor can not start. 9 before the start of the preparatory work 9.1 first hand rotating motor handwheel to make the machine run $number cycle, check whether there is a card lag phenomenon. 9.2 Check whether the vacuum degree meets the requirements. (table pressure -0.06mpa) 9.3 to replace the mold should carefully check the measurement disk, up and down module, fork, Guide groove and so on whether there is wear phenomenon, such as wear too large, should be given updates. 9.4 Check whether the capsules and materials meet the process requirements, such as unqualified, no boot production. 9.5 Check the electrical parts to be neat, the material position sensor to be flexible.