Troubleshooting method of cartoning packing machine

Troubleshooting method of cartoning packing machine

Cartoning packing machine is widely used in pharmaceutical, food, chemical and electronic industries. It is easy to use and does not need rich experience. However, if the horizontal box loader fails, it can be eliminated by the following aspects.

1. The paper box suction of the automatic loading machine of the drug board is not successful, which may be due to the blockage or leakage of the vacuum pipeline or the air distribution disk. The air circuit and the air distribution disk need to be checked carefully. The suction disk in the suction box mechanism needs to be replaced if it is aged. If the paper box shelf is not adjusted properly, it needs to be adjusted according to the adjustment steps again. If the suction disk angle is not correct, the working angle of the suction paper box needs to be reset in the human-computer interface.

2. There are several situations where the instruction manual of the rapid loading machine of the drug plate cannot be drawn down: the suction nozzle does not contact the instruction manual; there is no vacuum generated when the suction nozzle contacts the instruction manual; the suction nozzle is not strong enough, in this case, it is necessary to adjust the suction nozzle, reset the working angle of the suction instruction manual in the human-computer interface, and check the vacuum pipeline of the equipment to remove the blockage.

3. The angle of the tray box is not appropriate when several instructions are sucked down; the bottom instruction is not separated. It is necessary to readjust the paper nozzle and eliminate paper adhesion.

4. There is a problem with the lock of the carton of the medical automatic cartoner, the small tongue of the carton cannot be closed; the large tongue of the carton is not inserted properly, or it has become an arc shape; when the carton is closed, the large tongue on the outside (on the side of the operation surface) cannot enter the carton. It is necessary to check whether the front and back positions of the tongue closing are in place; adjust the height of the upper pressure rail at the tongue closing position, which should be 0.5mm-1mm higher than the carton; adjust the position of the upper pressure block at the tongue closing position.