What are the common failures of using semi-automatic capsule filling machine?

Semi-automatic capsule filling machine is suitable for 000#-4# capsule cap and body fitting and powder filling, suitable for small and medium-sized pharmaceutical factories, health care products factories, hospitals, veterinary medicine factories, research institutes, laboratories, pesticide factories and patients Small and medium batch production in many clinics and pharmacies. It adopts hole plug filling, intermittent operation, frequency conversion speed regulation, suitable for powder transfer or pellet-shaped capsule tablets to automatically complete the sac, sub-capsule, filling (rejection of waste sacs), lock sacs, and output of finished products. The latest structure: a fully enclosed ten-station work turntable with high accuracy, low noise, and strong practicability for domestically made machine-made capsules. Its key parts bearings and electrical appliances are purchased internationally, with stable performance and high-speed operation. The parts in contact with the medicine are all made of stainless steel and equipped with a dust collector, which meets the requirements of "GMP" standards.

The common failures of using semi-automatic capsule filling machine are detailed below. The vibration of the capsule filling machine is not ideal, adjust the voltage. The reed screw is loose, tighten the screw. The capsule shells are arranged in the worktable, the mouth is higher or lower, adjust the height of the misaligned plate and the guide rail. Too many capsule shells are turned upside down (more than 3%), the vibrator is not adjusted properly, due to the proper voltage adjustment or the size of the capsule shell is out of specification, select a qualified capsule shell. If the capsule shell is stuck on the platen and cannot fall down, replace the capsule shell or adjust the position of the dislocation plate and the plate hole.

The mold cannot be reset in the rail, the compression spring at the rear end of the rail is stuck or the capsule is deformed and stuck. Reinstall the spring or ejector rod, and push down the stuck capsule with the push rod. The guide plate in the mold is worn, which affects the low rate of capsule fit. Replace the capsule filling machine with a new mold or loose positioning on both sides, tighten the positioning nails, and the capsule is deformed or wet. Replace the capsule shell.