Maintenance And Repair Work Of Cartoning Machine

Cartoning machine maintenance

1) Lubricate the transmission parts inside the equipment every week, and do not add too much oil to avoid contaminants. The conveyor belts of each conveyor are adjusted every week to ensure that the conveyor belts do not run off.

2) When operating the equipment, remind each other to prevent personnel and equipment accidents caused by misoperation.

3) When cleaning the equipment, it is strictly forbidden for water to enter the electrical parts to avoid electric shock accidents and equipment accidents.

4) When operating the touch screen, you must be careful, you must operate it by hand, and disable other items instead of hand operation to avoid damage.

5) Check whether the screws and transmission parts of each connecting part of the equipment are loose every week, and check whether the clamp ring of the conveying chain of the silo is off.

6) During the operation of the machine, pay attention to whether the machine has abnormal noises and odors. It is necessary to quickly turn off the power and report for repair.

Cartoning machine repair

1) When inspecting and repairing the cartoning machine equipment, be sure to cut off the power supply and turn off the compressed air.

2) Check all transmission parts weekly to ensure that the transmission parts are not loose or abnormal.

3) Add lubricating oil to all transmission components in the chassis every week to ensure that the transmission of each component is flexible and no abnormalities. The main shaft and cam transmission parts should be greased.

4) Use compressed air to remove dust from the electrical control box every month, and fasten all wiring terminals, wipe the surface of the equipment and electrical appliances with a dry towel, and wipe the inside of the equipment chassis with cotton thread, so that there is no visible dust and dirt on the surface of the equipment, and the equipment appears. True colors.

5) Check the switch button and emergency stop button every month to ensure that they work normally and effectively.

6) The lubricating oil of the reducer is replaced every 5000 hours of operation, specification: hyperbolic gear oil.