The Advantages Of Granule Press And Maintenance

The Advantages Of Granule Press And Maintenance

The particle pressing machine adopts the principle of vacuum airflow and stainless steel combination structure. Built-in pulse blowing device, high material separation rate, can automatically control all kinds of powder. Suitable for high height, long distance, large amount of loading reactor, closed container, screening feeding, packing feeding, high-speed mixing machine and other directly supporting use.

Advantages of granule tablet press:

1. In the fluidized bed drying equipment, the fluid and solid particles are fully mixed, and the surface contact opportunities are many, which greatly strengthens the heat transfer of the two phases, so the temperature in the bed is relatively uniform. At the same time, it has a very high heat capacity coefficient (or volume heat transfer coefficient).

2. Compared with the old box drying equipment or rotary cylinder drying equipment, the fluidized bed drying equipment has the advantages of short material residence time and high drying speed; it is also suitable for drying some thermosensitive materials.

3. The equipment is simple, easy to manufacture, easy to maintain, and easy to magnify the equipment.

4. The residence time of materials in the fluidized bed drying equipment can be adjusted according to the process production requirements. When the water content of the finished product changes or the water content of the raw material fluctuates, it can be adjusted appropriately.

5. Continuous production and intermittent operation.

Maintenance of granule tablet press:

1. Regularly check the machine parts for 1-2 times a month to check whether the worm wheel, worm rod, bearing, pressure wheel, crankshaft, upper and lower rail guide are flexible and wear. Any defects should be repaired and used in time.

2. When one use or shutdown, the residual powder should be removed and the residual powder of each part of the machine should be brushed. If the shutdown time is a long time, all the die must be removed, and all the machine will be wiped clean, the bare surface of the machine parts coated with anti-rust oil, with a cloth cover.

3. The maintenance of the punch die should be placed in the box, so that all the punch die into the oil, and to keep clean, do not make rust and touch, can avoid using the loading error and is helpful to grasp the loss situation.

4. The place of use should be cleaned often, especially for the manufacture of medicine and edible tablets, there should not be gray sand and flying dust.

5. Electrical components should be paid attention to maintenance, checked regularly, and kept in good running condition. The cooling fan shall be regularly cleaned up with compressed air.

6. Electrical components should pay attention to the working environment conditions (temperature, humidity), which will extend the service life of the components in a good environment.