Labeling machine maintenance and maintenance skills

As the various of bottles at the market, so the manufacturers use labeling machine is also different.Now the most common type of labeling machine mainly include: marking machine, round bottle labeling machine, beer labeling machine, semi-automatic labeling machine, labeling machine, automatic labeling machine, automatic labeling machine, labeling machine, automatic paste label making machine, hot melt glue labeling machine.

Guangdong Rich Packing Machinery Co., Ltd., concluded that, in and out to adjust the bottle of star wheel and screw into the bottle, the pressure bottle labeling machine shall prevail.Firstly adjust into the bottle of star wheel, when pressure bottle head just over the bottle, adjust into the bottle of star wheel, make the bottle is located between the star wheel groove.Bottle feeding screw adjustment: will be subject to into the bottle of star wheel, and when the bottle in the bottle of star wheel groove right in the middle, the adjusting screw, the screw into the bottle of lateral displacement generated by tight bottles but not.A bottle of star wheel adjustment: when the pressure bottle just raise head, adjust the star wheel to make the bottle in the middle of star wheel groove.  

Guangdong Rich Packing Machinery Co., Ltd.. in peacetime maintenance and maintenance of the labeling machine is summarized some maintenance tips, hope we can help to you:
1. To mark the center of the brush for label and balanced on both sides.The brush is perpendicular to the surface of the container.Pressure brush sweeping container for overlap: a single pressure brush to 10 mm to 15 mm, brush combination pressure for 5 mm to 10 mm.The location of the sponge cleaning brush distance is 1 mm ~ 2 mm.The adjustment of the pressure bottle.Pressure bottle without the bottle should be 20 mm lower than with the bottle.The box to grasp the regulation of the hook position: the up and down, left and right sides of the hook in the same vertical plane and even demanding in the paper, can grasp the smoothly.Label supply roller to adjust: when there is no label, tag clamp to pressure box of the front and tagged tag near the hook refers to cannot be crushed.   

2. Scrape the adjustment of the rubber sheet and rubber roller, scraping rubber sheet and rubber roller cannot appear over the whole length of clearance, if there is a gap can by adjusting the eccentric bolt to adjust the scraping rubber sheet.Rubber roller and standard plate: the regulation of standard plate and rubber roller between just touch each other without any pressure.Excess clearance is too large, the plate glue, glue.Gap is too small, contact too tight, the glue will be crowded go, half the board without glue.Practice has proved that the gaps between the roller and between 0.1 mm to 0.2 mm is the best.Can be done by adjusting the rubber roller lower bearing seat, was carried out on the upper part of the rubber roller bearing adjustment when necessary.

3. The center line of the box, the center shaft and label paper and tangent, the plate central axis into a line of three, adjust the plate and label paper tangent distance (0), and then move the box nearly 1 mm ~ 2 mm.On both sides of the paper in the box and layering of the clearance should be between 0.8 mm to 1 mm, clearance is too large to cause the paper in the box shift, appear inclined, push gap is too small will cause the confusing.