Powder Rotary Tablet Press Machine Die Loading Method and Installation

Powder Rotary Tablet Press Machine Die Loading Method and Installation

Powder Rotary Tablet Press Machine Die loading method

 Before the die device, first remove the dust-proof plate, hopper, powder feeder, semi-circular cover and other parts, and wipe the working surface of the turntable, the die hole and the installed die one by one. Prepare the work according to the following. Steps to install.

(1) Medium-mold device: Rotate the middle-molded fastening screws on the turntable one by one to the outer circle of the turntable. Do not let the middle mold fit into the head of the screw. The medium-mold device is very tight. Flat, the copper rod can be penetrated from the upper punching hole, and gently punched in with a hammer. After the middle mold enters the die hole, the plane cannot be higher than the plane of the turntable, and then the screw is fastened.

(2), the upper punching device: the tongue of the upper rail guide should be put on the notch, the vegetable oil should be applied to the tail of the punch, insert into the hole one by one, and rotate the punch with the thumb and forefinger to check the head. The upper and lower sides of the mold are flexible, and no hard rubbing is required. After the lungs are installed, the tongue is pulled down.

(3) Undershooting device: Pull the small door on the main body and install it from the main hole. The loading method is the same as the upper punching. After the loading, the wafer must be flattened.

(4) After the complete set of the die, install the removed parts in the original position, continue to rotate the test wheel by hand, rotate the turntable 1-2 turns, observe the upper and lower punches into the middle die hole and act on the curved track guide. It must be flexible and non-touching and hard rubbing. Start the motor and make the empty car run for 2-3 minutes. It can be put into production smoothly and normally.

installation

1. The tablet press of Guangdong Rich Packaging Machinery is packed in the whole box. After unpacking, it can be moved to the appropriate place of use. After the pad is leveled, it can be used. If the position is fixed, the foot nail can be added.

2, our tablet press electrical circuit device, should pay attention to the voltage, the user did not propose, will be 380 volts, and should pay attention to the direction of motor rotation when wiring, must be consistent with the arrow on the machine, do not reverse, for To ensure electrical safety, an effective ground wire must be attached.

3 This unit should be used in a dry, clean, well-lit room.