High-Speed Rotary Tablet Press Machine Common Problems And Solutions（NO.1）

High-Speed Rotary Tablet Press Machine Common Problems And Solutions（NO.1）

The Pressure Wheel Part Can Be Divided Into An Upper Pressing Wheel And A Lower Pressing Wheel, And Is Also A Common Fault Analysis And Solution For Adjusting The Pressure Of The Tablet And Increasing The Protection Device:

1.The Wear Wheel Of The Pressure Wheel Wears The Outer Circle Seriously, Which Will Cause The Tail End Resistance To Be Large. The Pressure Rwheel Must Be Replaced Again. When The Inner Hole Of The Pressure Roller And The Pressure Wheel Shaft Are Seriously Worn, The Pressure Roller Or The Pressure Wheel Shaft Must Be Replaced. The Deformation Will Be Mainly Caused By Excessive Pressure. Most Of Them Are Caused By Excessive Adjustment Of The Material. In This Case, The Pressure Wheel Shaft Needs To Be Replaced, The Material Is Adjusted, And The Pressure Is Adjusted Again.

2.Pressure Wheel Shaft Bearing Lacks Oil Or Damage: Regularly Lubricate And Maintain The Pressure Wheel Shaft Bearing, And Timely Replace The Adjustment System (pressure Regulation, Filling Adjustment). The Adjustment System Includes Pressure Regulation System And Filling Adjustment System. Common Chapter Analysis And Solutions:

(1) Adjustment Failure: Under Normal Circumstances, The Adjustment Failure Is Caused By The Looseness Of The Handwheel Screw, The Adjustment Of The Handwheel Does Not Work, Or The Adjustment Of The Worm Wheel Is Caused By Jamming. In This Case, Check The Adjustment Handwheel And The Worm Wheel, And The Fastening Screw Can Be Tightened. Lubricate The Rotating Worm Gear And Other Measures To Solve.

(2) Overload Protection System

The Common Fault Analysis And Solution Of The Overload Protection System, The Main Reason For The Frequent Alarm Is That The Pressure Setting Of The Pressure Overload Overload Protection Spring Is Too Small. The Solution Is To Adjust The Pressure Handwheel, Reduce The Pressure Or Increase The Overload Protection Bullet. Constant Pressure.