Instructions for installation and operation of blister packaging machine

Matters needing attention for aluminum-plastic blister packaging machine

1. There is a rubber wheel under the blister packing machine seat, which can be moved.

2. Full-time personnel training operation and maintenance.

3. Access the ground wire according to the location specified on the ground plate.

4. The tablet blister packaging machine should be kept clean and tidy.

5. All parts of the capsule blistering machine must be refueled before production (refer to the operation provisions).

6, when the blistering machine leaves the factory transmission case watchband lubricating oil, must be refueled before production.

7. Oil-free air compressor is recommended.

Blister packaging machine molding, heat sealing, indentation and other parts of the pressure should not be too large, otherwise affect the service life. Forming indentation of the pad rotation should have a millimeter or so floating room.

Operation procedure of aluminum plastic blister packaging machine

The first temperature controller of the working table controls the shaping temperature. It is normally equipped with 90C and 100C˚ respectively. The second temperature controller is up or down ˚ c heat sealing.

2. Put down the pressing block on the feeding roller, the temperature of the forming heating plate is in place, then open the main machine, the plastic PVC is formed first, the forming bubble eye is in line with the hole position of the hot sealing mold. Note that the hot sealing mold base is set down with the handle to press the hot sealing mold, and the aluminum foil will drive blanking. Observe whether the plastic (PVC has been formed on the surface of the machine) moves around or not. If there is a deviation, adjust the starting direction of the starting pressure roller seat.

3. If the aluminum foil moves to the left and right, the adjustable knuckle-roller seat handwheel can be adjusted. Adjustable box movement if forward and backward deviation.

Moderately open after 4, heat sealing cutting normal feeder gate, make medicines (pills capsule, icing) right amount into the loading chamber, if there is a small amount of particles can be artificial fill, first note: during grain filling roller roller mill hands and snagged the aluminum foil and other molding bubble eye over the edge of the roller is lack of grain, don't force to repair, the fill hole location is not allowed, were brought into drugs, more serious influence synchronization, light it in aluminum foil sealing glue mold, right to set machine processing.

5, due to the increase in the weight of drugs, aluminum foil tension and machine temperature gradually change program, may produce forming and heat sealing out of sync phenomenon, advance or lag, check the plastic PVC and aluminum foil is shaded, then can be adjusted by the fine tuning mechanism on the machine. The fine-tuning mechanism is adjusted backwards and forwards in the mold due to its adjusting distance or the box body. So in the boot should be placed in a neutral position, can move backwards and forwards, can also be used in front of the box movement adjustment, correct movement, the plate to wait for more than ten versions of the correct, so in the end, do not adjust to adjust. 6, plastic aluminum foil hot sealing quality (adhesive uniform firm flat normal) by temperature or pressure, the flatness of the reticulum plate to see, if there is poor heat sealing, the general appropriate temperature, the general appropriate temperature, slightly lower pressure, adjust the temperature, the most adjust the screw book pressure.

7. Blanking out of position, cut off with layout offset, stop the machine and move the hand adjusting box, the mold can be shifted.

8, in the daily operation knowledge, for the work must understand the structure principle, operation by the transmission of the push rod roller CAM, up and down stroke, cover template position fixed die, in blister adverse condition, pay attention to the forming die or heat sealing to top dead center, binding column nuts, do not pay attention to words easy to fail, ejector seat of needle roller bite dead phenomenon, elimination method.