Daily maintenance of high speed aluminum plastic blister packaging machine

During the operation of high-speed aluminum plastic packaging machine, timely fill in batch records and equipment operation records, pay attention to the high-temperature parts of molding and heat sealing, be careful to scald the moving parts, and strictly prohibit using foreign matters or hands to reach in, so as to avoid accidents. Regularly check the wiring harness connection, avoid friction with other moving parts, damage wires, causing short circuit, leakage molding, heat sealing, indentation and other parts, and the pressure is not high Should be too large, so as not to affect the service life of the packaging machine;

When the high-speed aluminum-plastic blister packaging machine is just started up, the preheating temperature of each heating part can be appropriately increased. After the stable operation, the preset temperature can be appropriately decreased to ensure the function, so as to protect the heating elements and keep the packaging machine clean and beautiful. It is not allowed to scratch or knock the stainless steel surface with hard objects, and it is not allowed to put debris in the movement channel to protect the mold, cutting knife and heat sealing reticle plate packaging process In case of abnormal operation, the machine should be shut down in time. After troubleshooting, the machine can run again. After work, press the emergency stop switch to close the valves of compressed air and cooling water.

The daily maintenance of high-speed aluminum plastic packaging machine is also very important

1. Check the machine parts regularly, once a month, check the worm gear, worm, bolts on the lubrication block, bearings and other moving parts for flexible rotation and wear. If any defect is found, it should be repaired in time, and it should not be used reluctantly.

2. The fast aluminum plastic machine should be used in a dry and clean room, and should not be used in the place where the air contains acids and other corrosive gases.

3. After the adjustment of the aluminum plastic machine is finished or stopped, take out the rotary drum to clean and brush the residual powder in the bucket, and then install it properly to prepare for the next use.

4. If the machine is out of service for a long time, the whole body of the machine must be wiped and cleaned. The smooth surface of the machine parts must be coated with antirust oil and covered with a cloth.