Structure principle of capsule aluminum-plastic blister packaging machine

The use of capsule aluminum-plastic blister packaging machine packaging products can improve productivity, reduce labor intensity, adapt to the needs of mass production, and meet the requirements of sanitation. The packaging process includes filling, wrapping, sealing and other major procedures, as well as the related procedures before and after, such as cleaning, feeding, stacking and disassembly, etc. In addition, the packaging also includes measuring or printing the date on the package. Heat sealing cutting modestly open after normal feeder gate, make medicines (pills capsule, icing) right amount into the loading chamber, if there is a small amount of particles can be artificial fill, first note: during grain filling roller roller mill hands and snagged the aluminum foil and other molding bubble eye over the edge of the roller are lack of grain, don't force to repair, the fill hole location is not allowed, were brought into drugs, more serious influence synchronization, light in aluminum foil sealing glue right mould, machine processing to set. Put down the pressing block on the primer roller, forming the heating plate temperature is in place, and then open the main machine. Plastic PVC is formed first, forming the bubble eye is in line with the hole position of the heat sealing die. Pay attention to the heat sealing die seat with the handle to put down the heat sealing die and press the aluminum foil, and the aluminum foil will lead to punching. Observing whether the plastic (refers to the machine board surface has been formed PVC) moves left and right. If there is bias should adjust the guide roller to mobilise direction, in the daily operation knowledge, aluminum-plastic packaging machine for capsule operating work must understand the structure principle, by the transmission of the push rod roller CAM, up and down stroke, cover template position fixed die, in blister adverse condition, pay attention to the forming die or heat sealing to top dead center, binding column nuts, do not pay attention to words easy to fail, ejector seat of needle roller bite dead phenomenon, elimination method. The composite structure is made of polyester, aluminum foil and polyethylene (PET/AL/PE), which is characterized by good printing adaptability and good gas and moisture resistance to medicine.

Capsule aluminum - plastic blister packaging machine good barrier performance due to the choice of raw materials aluminum foil and plastic blister sheet. The aluminum box has a highly dense metal crystal structure, and has good insulation and shading properties. Compared with bottled medicine, the advantages of blister packaging Z large is easy to carry, save raw and auxiliary materials, light weight, convenient transportation, good sealing performance, meet the requirements of environmental protection and green packaging; Can pack any special-shaped products, packing without additional cushioning material.

Be transparent packaging products, beautiful appearance, easy to sales, and is suitable for mechanization and automation of packaging, is advantageous for the modern management, saving manpower, high efficiency can reduce drug pollution in the process of carry and use, and blister packaging in the gas barrier property, moisture permeability, health, safety, production efficiency, dose accuracy and extend the shelf life of drugs and so on also has obvious advantages.

Capsule aluminum-plastic blister machine packaging materials on the predetermined sealing and cutting parts may deviate from the correct position, and produce errors. In order to eliminate errors and achieve the purpose of correct sealing and cutting, the packaging design must consider the problem of automatic positioning, screw down the ball nut on the indentation cover plate, take down the indentation cover plate and place it on the operating table.

Unscrew the fixed screw of the module, remove the type and wipe it clean with 95% ethanol solution, then put it in the storage box and store it in the designated cabinet, and install the indentation cover plate on the blister packaging machine in the reverse order of disassembly. To solve this problem, most of the continuous photoelectric automatic positioning system design is completed according to the positioning standard of packaging materials.