High Speed Press machine die mounting

High Speed Press machine die mounting

Guangdong Rich Packing High-speed Press machine die device, first of all, to remove the hopper, powder, feeder rack and other parts, and the turntable face, mold hole and installation of the die by wiping clean, do a good job of preparation, according to the following steps to install. (1) Medium mold device: will be on the turntable of the medium mold fastening screws from the turntable out of the circle area flat, do not make the middle mold into the head of the screw touch, the medium mold device is very tight, the placement should be flat, can be used in the punching rod (random tool) on the punch through, for the hammer into the mold.

Konseng its plane should not be higher than the turntable plane is qualified, and then tighten the screws.

(2) Upper punching device: the upper rail disk gap should be embedded in the tongue, the tail of the middle pole coated with some vegetable oil, inserted into the hole by piece, with the thumb and index finger to rotate the lever, check the head into the middle mold up and down and rotation flexible, must not hard wipe phenomenon as qualified, all installed should be embedded tongue down.

(3) The punching device: pull the small door on the main body, by the main body of the round hole installed, the installation method and the upper flush, after the installation must be Gaiping the round sheet.

(4) After all the die sets, the removed parts will be installed in the original position, with the hand to continue to turn the test handwheel, so that the turntable rotation 1-2 rpm, observation up and down into the middle mold hole and action on the curve, must be flexible without collision and hard wipe phenomenon, start the motor, so that empty car operation for 2-3 minutes, smooth and normal

Guangdong Rich Packing specializes in the production of high-speed press, please contact us if necessary.