Factors to be considered in preventive maintenance of high speed aluminum plastic blister packaging machine

There are two basic elements in the preventive maintenance of full-automatic blister packaging machine. The regular inspection of the equipment to find out the shutdown or other faults can eliminate the equipment maintenance for adjustment or repair in the initial stage.

Maintenance and prevention of blister machine: equipment maintenance is not the ultimate goal, but an activity to meet the requirements of production for equipment and maintain the improvement of equipment utilization rate. It is basically hoped that in the design and manufacturing stage of the equipment, the performance of the equipment can be improved, and the equipment that needs no maintenance, needs little repair or is easy to repair in case of failure is designed, so as to reduce the maintenance of equipment workload.

Routine maintenance of aluminum plastic packaging machine: daily or weekly equipment inspection, cleaning, adjustment, lubrication, parts replacement and other activities. This is to prevent equipment aging, delay aging speed, extend the service life of equipment, and effectively reduce repair costs.

Improvement and maintenance of aluminum plastic blister packaging machine: when the equipment fails, in addition to repairing the equipment, the overall improvement of the equipment should be carried out, such as changing the design and improving the materials, so as to enhance the operation ability of the equipment and bring convenience for the future maintenance work. Equipment improvement is not only necessary for maintenance, but also according to the requirements of production.

8 rules for maintenance of high speed aluminum plastic packaging machine

1. Aluminum plastic packaging machine should be wiped, cleaned and kept clean.

2. Check the operation of the aluminum plastic packaging machine frequently, and deal with the problems found in time.

3. According to the lubrication requirements, lubricate the equipment on time

4. Do not cut off water in cooling parts during operation. Before start-up, supply water first, and then heat the heating parts; when the production is terminated, stop the water supply after the heating parts reach the normal temperature.

5. The surface of the heat sealing roller shall be kept clean, and the fine copper wire brush shall be used to remove the attachment under the heating state. At the same time, the operator should pay attention to the operating range and the distance between the hand, arm and body and the heating roller to avoid scalding.

6. After the work is finished, cut off the power supply first, and then turn off the water source and air source after the heating parts are cooled to normal temperature.

7. When using or storing abrasives, avoid bumping and scratching, and do not contact with corrosive substances.

8. When the aluminum plastic packaging machine is not used for a long time, the accumulated water in the water and gas paths should be blown out with compressed air, and each part should be coated with oil and covered with plastic.